Schneider 100 Amp 600 Volt MPPT Charge Controller


Schneider 100 amp MPPT charge controller for 24 or 48 volt battery

SKU C-XWMPPT100 Categories , ,


Schneider 100 Amp MPPT 600 Volt Charge Controller

Higher voltage array configurations minimize the overall amperage of the array, dramatically reducing the size of the wire needed to transmit the power from the array to the charge controller. The XW100 MPPT 600V Charge Controller allows for array positioning at much further distances than typically considered, with huge savings in the cost of transmission wire.

It can be used with PV arrays with voltages ranging from 195 to 550 VDC and can support an output of up to 100 amps into the battery for battery voltages of 24 or 48 VDC. The PV open circuit voltage must not exceed 600 VDC. With a maximum of 100 amps output, a single charge controller can handle array sizes up to 6,000 watts on a 48 volt battery bank.

The XW charge controllers are the best selection to use in conjunction with Schneider XW inverters, intended for grid-tie, net-metering applications or off-grid PV production. Schneider’s proprietary Enhanced Interactive operating mode is the most efficient operating solution to balance battery charging, household loads, and selling to the grid.

Any DC circuit breakers or fusing on the solar array side of the controller (solar disconnect and/or combiner box) must be rated for high voltages of 600 volts.

The XW controllers have a configurable auxiliary output to drive a relay for load control or to turn on devices such as a vent fan or indicator alarm.  Auxiliary output can be configured to perform only one function at a time. Built in PV ground fault protection allows code-compliant installation without the need for additional ground fault protection. Standby and night-time power draws less than one watt.

 30″ x 8 5/8″ x 8 5/8″, weighs 45 lbs.

3 year warranty, 2 additional years with product registration

Additional information

Weight 50 lbs


File Attachments


No products were added to the wishlist.